MONON BOARD

Monon Scale Modeling => Generic Modeling Discussion => Topic started by: Roger Nulton on November 12, 2020, 09:52:07 pm

Title: Monon Lettering Font
Post by: Roger Nulton on November 12, 2020, 09:52:07 pm

Has anyone discovered a lettering font like the italicized "Monon" logo?  I am trying to letter my model of the "Monon Grill" in Greencastle, and the photos of the lettering that I have (attached) were taken at an angle that is too sharp to fix by my photo editing software program.
Thank you for any help,
Roger Nulton

Title: Re: Monon Lettering Font
Post by: Stew Winstandley on November 13, 2020, 09:34:12 pm

Roger,

I used winzip to create a zip file of MONON_.TTF . See if you can unzip it into a TTF and then put it into your c:\windows\fonts folder.

Title: Re: Monon Lettering Font
Post by: Roger Nulton on November 14, 2020, 12:59:17 am

Stew,
That's terrific!  Thank you very much.  And thanks for the instructions on how to access it: I would never have figured that out.
Where did this come from, out of curiosity?
Roger

Title: Re: Monon Lettering Font
Post by: Rick Berg on November 14, 2020, 09:36:45 am

Sometimes you can double click the install file and it will prompt you to install it also.....

Title: Re: Monon Lettering Font
Post by: Stew Winstandley on November 16, 2020, 03:22:08 pm

I think Tom Kepshire provided the font file many many years ago. My file has a 2004 date on it.

Title: Re: Monon Lettering Font
Post by: Roger Nulton on November 17, 2020, 04:55:27 pm

Yes, it was Tom as I recall.  I remember a discussion about the font years ago but never followed up since I had no immediate need.
Thanks again Stew.  And thanks to Rick as well.  His method for installing the file works also.
Roger